Barska Biometric Safe User Manual

Barska Biometric Safe User Manual

5. Remove tamper resistant cover from initialization button.

Press and hold initialization button on the inside of the door as

the battery is reinserted, you will hear 1 beep followed by 2

consecutive beeps, release initializing button the LED light will

flash green accordingly with the beeps. This may take a few

seconds. Replace tamper resistant cover back onto

initialization button.

Initialization deletes all fingerprints stored in the module. Now

any fingerprint can open the safe.

F. Replacing Batteries

1. With the door open unscrew battery cover and remove

2. Press wake-up button a few times to release remaining

electronic power.

3. Reinstall new batteries and replace battery cover.

G. External Battery Pack

Note: Included with select models

Use external battery pack only when batteries are low

1. Install batteries; note the polarity of the placement of batteries

2. Plug the external battery pack into the pink hole on the lower

left side of the fingerprint module

3. Press the wake-up button to open safe door by scanning a

fingerprint

H. Opening the Safe with Key

Back up key access is located near the door handle of the safe

Entry access can either be a logo plate OR key cover. Key

access is for emergency use.

Safe Plate

Use the screwdriver to twist the screws on the safe plate. Then

open the door with the key. After opening door, take out the key

and return the safe plate.

Gently lift off the key cover and then open the door with the key.

After opening door, take out the key and return the key cover

back into place.

I. Sound Options

To Turn Off Beep Sound

With the door open remove tamper resistant cover from

initialization button. Press & hold initialization button until green

light flashes, release initialization button. Replace tamper

resistant cover back onto initialization button. Beep is now

To Turn On Beep Sound

With the door open remove tamper resistant cover from

initialization button. Press & hold initialization button until green

light flashes and you hear one beep. Replace tamper resistant

cover back onto initialization button. Beep is now enabled

See reverse side for more information

Related Manuals for Barska Biometric Safe

Pistol keypad safe (2 pages)

Biometric lock box (2 pages)

Biometric safe (2 pages)

Digital keypad safe (3 pages)

1.01 cubic ft white keypad jewelry safe (2 pages)

Key safe (2 pages)

Key cabinet with combination lock (1 page)

Key safe (2 pages)

Biometric safe (2 pages)

Depository safe (6 pages)

Biometric compact portable lock box (2 pages)

Digital portable safe (2 pages)

Key safe (2 pages)

Key safe (2 pages)

Depository safe (2 pages)

Summary of Contents for Barska Biometric Safe